3D wheel alignment in Kaunas
We check and adjust wheel geometry on a Hunter (USA) 3D alignment stand. The measurement shows exact angles rather than rough values, so it also catches what is only starting to drift — before a tyre wears down on one edge.
Wheel alignment in Kaunas is not only needed after a pothole. Geometry drifts gradually: after tie rods or shock absorbers are replaced, after a hard hit against a kerb, or simply over time. The first signs are the car pulling to one side, the steering wheel sitting crooked when driving straight, and uneven tyre wear.
Measuring on the 3D stand takes a few minutes; adjustment time depends on the car. On some cars the angles are set quickly, on others worn suspension parts have to be sorted out first. If we can see that adjusting makes no sense, we say so straight away — we do not charge for work that will not hold.
Before and after the job we hand you the measurement report showing what the angles were and what they became. That lets you compare the result and come back to the same figures a few months later.
What the service covers
- Suspension inspection before measuring
- All wheel angles measured on the Hunter 3D stand
- Toe and other adjustable angles set to spec
- Measurement report before and after the job